4
the ixture. Operating the ixtures out of water will
damage the LED and void warranty.
2. Insert the ¼” x 1” bolt into the light mounting
bracket. Align the bracket to the loat bracket by plac
-
ing the bolt through the light mounting hole (mount-
ing bracket is on top of the loat bracket) as shown in
Fig.7
Fig 7
3. Install the ¼” Flat Washer, ¼” Lock Washer and
¼” Nut against the underside of the loat tab as shown
in Fig. 8. Tighten the nut until snug using the 7/16”
wrench.
Fig 8
lat washer
lock washer
1/4” nut
4. Adjust the angle of the light as desired and tighten
the ¼” x ½” bolts on the sides of the mounting bracket
until snug. For more uniform illumination, it is best to
have all three ixtures at the same angle.
5. Repeat steps 1 through 4 for the remaining ixtures.
Assembled light ixtures are pictured in Fig. 9. Note
the orientation of the lights and mounting brackets.
Fig 9
6. Using the cable ties, tie each ixture cord to bottom
leg of mounting brackets using the holes provided.
The will act as a strain relief and will keep the cord
from being damaged by the fountain and balance the
unit properly. Next, cable tie the main power cord to
the loat as shown in Fig. 5.
Fig 5
7. Upon installation of the assembled unit, connect
your LED light kit to your ield installed GFCI pro
-
tected outlet and timer.
Instructions for mounting LED3S19 on models:
8400VFX, 800JF, 2.3VFX, 2.3JF, 3.1JF, 3.3JF,
5.1JF, 5.3JF, 5.1VFX, 5.3VFX, 7.3JF
1. Install the mounting brackets to the light ixtures
as shown using ¼” lock washers and ¼” x ½” bolts.
Hand tighten only at this time.
Fig 6
Important Note: Installation of the LED light ix
-
tures on the above listed aerating fountain units with
the mounting brackets oriented as shown will ensure
proper submersion of the light ixtures. Each ixture
must be partially submerged in order for lights to oper-
ate properly. Other applications for these ixtures must
provide at least the same submersion to properly cool
Summary of Contents for LED6S19-150
Page 11: ...11...
