MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning
before use.
It is important that you read, fully
understand and observe the following
safety precautions and warnings.
Careless or improper use of the unit
may cause serious or fatal injury.
Read, understand and follow all
warnings and instructions in this
manual and on the unit.
Always wear eye, head and ear
protectors when using this unit.
Keep all children, bystanders and
helpers 15 m away from the unit.
If anyone approaches you, stop
the engine and cutting attachment
immediately.
Be careful of thrown objects.
min
-1
Shows maximum shaft speed. Do not
use the cutting attachment whose
max rpm is below the shaft rpm.
Gloves should be worn when
necessary,e.g., when assembling
cutting equipment.
Use anti-slip and sturdy footwear.
Choke - Run position (Open)
Choke - Start position (Closed)
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See “MAINTENANCE”.
START
On/Start
STOP
Off /Stop
Fuel and oil mixture
Idle speed adjustment
Priming pump
4
Guaranteed Sound power level
Hot Surface – Contact with
hot surface can cause serious
burns.
Blade thrust may occur when the
spinning blade contacts a solid object
in the critical area. A dangerous
reaction may occur causing the
entire unit and operator to be thrust
violently. This reaction is called blade
thrust. As a result, the operator may
lose control of the unit which may
cause serious or fatal injury. Blade
thrust is more likely to occur in areas
where it is diffi cult to see the material
to be cut.
Indicate handle location. Do not
attach handle above this point.
6
Summary of Contents for KZ-4000BC-PRO-2S
