110/162
400 4F_11319.4.enu
Safety instructions for changing xenon bulbs
Before changing a bulb, always switch off the headlights
and isolate them from the power supply.
Do not probe into the bulb socket.
The electrical connection between headlight and ballast
carries a high voltage: do not break this connection.
Never operate the ballast without a bulb, as this could
cause dangerous arcing at the bulb socket and result in
damage.
Allow the bulb to cool down before you commence work.
Wear protective goggles and protective gloves when
changing bulbs.
Danger of flying splinters of glass!
The glass body of a xenon bulb is pressurised and can
shatter.
Always hold the bulb by the base.
Operate xenon bulbs in closed headlights only.
Dispose of the spent xenon bulb as hazardous waste.
Electrical connection
Before connecting, always interrupt the circuit by switch-
ing off the battery master switch.
Use only the factory-installed wiring harness for electrical
connection.
E
LECTRICS
Summary of Contents for PistenBully 400 4F
