7
6
INSTallaTION - RONDa wM / PETRa wM
Step 3 – CONNeCtINg the pOWer SOurCe
1
Remove the protective sticker
covering the sensor. Keep away from
the sensor range and check that no
objects are in front of the sensor.
2
Connect the soap pump
connector to the matching
connector from the sensor.
Please note that since the
connector is waterproof, some
friction might apply.
O-RING VISIBLE –
NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE –
CONNECTED PROPERLY
IMPORTANT: the 4 contacts connector should be connected properly so that the white
o-ring is not visible and a clicking sound is heard.
PAY ATTENTION: If the 4 contacts connectors will not be connected properly, the pump
will work continuously.
2a
For battery versions: install the
battery box on the wall underneath
the sink and connect the battery
connector
FROM THE SOAP DISPENSER
TO THE bATTERY bOx
2b
For transformer versions: plug the
transformer into the electricity
socket and connect the transformer
connector
FROM THE TRANSFORMER
TO THE SOAP DISPENSER
3
Wait about 10 seconds before
you put your hands within the
sensor range to avoid entering the
adjustment mode.
10
SECONDS
AbOuT
INSTallaTION - RONDa / PETRa
Step 1 – INStallINg the SOap dISpeNSer
1
Cut an adequate opening in the wall for
the dimensions of the soap dispenser
base (where you want to install the
spout) and the corrugated tube.
Disconnect the soap dispenser body with
the rosette from the base by unscrewing
the set screw.
SET SCREW
2
Mount the soap dispenser base into the
opening in the wall and secure it using
the two anchors provided in the package.
Important: The soap dispenser base
should be installed so that the outside
surface of the finished wall falls between
the minimum and maximum lines marked
at the base.
3
Assemble the temporary protective soap
dispenser base cover.
4
Assemble the corrugated tube to the
soap dispenser base and make sure it
stays outside the wall when you do the
tiling.
