11
10
FIllINg THE SOaP TaNk
1
unscrew the soap tank from the pump assembly
and pull it out of the bottle support.
2
Fill in the liquid soap up to the top line.
3
Insert the bottle inside the bottle support.
4
Screw the soap tank back to the pump assembly.
Make sure the tank is firmly secured into place.
5
Press the refill button located at the back of the
pump assembly until soap starts coming out of
the soap dispenser spout. This operation can also
be done using the soap dispenser remote control
Refill function.
6
NOte:
Once the soap in the soap tank has reached
the bottom line the soap tank should be refilled. To
refill the soap tank please refer to steps 1-5.
SETTINgS aDJUSTMENT wITH a REMOTE CONTROl
If available, the soap dispenser remote control can adjust the dispenser’s settings.
To use the remote control hold it in front of the sensor at a distance of 10-15cm (4-6”).
Attention: The remote control will not operate out of the recommended range (too close
or too far).
The remote control can be used to adjust the following functions:
1-SOaP QUaNTITy
The 1-4 drop keys allow the user to choose the desired soap quantity. *
4
2.1 to 2.3 cc
3
1.6 to 1.9 cc
2
1.2 to 1.6 cc
1
0.7 to 0.9cc
Indication: continuous blinking of the light in the sensor eye.
* The exact dosage depends on soap viscosity.
2
3
1
4
2-aDJ
This function resets the sensor back to factory
settings.
Indication: 2 blinks of the light in the sensor eye.
3-TEMPORaRy OFF FUNCTION
This function temporary disables the
dispenser. use this function to preform
maintenance in front of the sensor without
activating the system (for example: cleaning).
The soap dispenser will shut off for one minute
after this button is pressed once.
To return to normal operation before the
minute is over, press the On/Off button again.
Indication: OFF – 2 fast blinks, ON – 4 fast blinks
4-FIll THE SOaP TaNk
Once the soap tank has been filled \ refilled,
press the FILL button. The pump will run for one
minute, priming the piping with soap. Once soap
begins dispensing from the spout, priming is
complete. press the FILL button again to stop the
priming before the minute is over.
Indication: continuous solid light in the sensor
eye.
