15
Product Installation and Assembly
Assembly of the Base
If insist on placing device
on easily scratched
surfaces such as wooden
or tiled floors, make sure
to lay down a mat or any
other kind of floor
padding underneath.
03
Once the base is set up,
place the level in the center;
if the bubble inclines to the
sides, use the open-end
wrench in the toolbox to
adjust the foot screws and
measure again until the
base is perfectly leveled for
an optimum experience.
04
Remove the base frame
marked with a sticker “5”,
and set it aside for assembly.
Proceeds to lift up the base
which weighs approximately
85kg and place it on a flat
surface at least 60cm away
from the wall.
The side with sticker “1”
should face forward, as
shown in the picture.
power outlet
60CM
01
02
85KG
