16
Take out the large hex
hey/allen key from the
toolbox and remove the four
screws tightened at the base
frame’s foot on two sides
and put them aside.
Assembly of the Back Support
Take out a supporting rod
marked with sticker “2” and
insert it into the vertical tube
on the left side of base with
sticker “1”.
Take out a supporting rod
marked with sticker “3” and
insert it into the vertical
tube on the left side of base
with sticker “1”.
Lift up the hose a little bit
so as to insert the
supporting rods until
they have been lowered
to the very end.
To complete this procedure,
you need to make sure that
the top of the hose aligns
with the surface of the base
frame as shown in the
picture.
Secure the height
adjuster by locking it, in
case of accidental falling
of back support when
installing.
05
06
07
08
09
10
The surface of joint may leave some scratches when assembling due to the necessary test at
the factory, but it won't affect your use of KAT Walk mini.