uBreakiFix Fixture Install & Maintenance Guide
11
STEP 10
Lift the larger frame sections and push against the
wall.
STEP 11
While one person holds the frame against the wall,
determine the fi nal location and adjust leveling feet
as needed to level the wall.
STEP 12
Mark with a pencil the large holes in the furring strips.
(4 holes per 4’ segment)
STEP 13
Lay the wall system back safely on the floor. Drill the
marked holes with a 1/2” drill bit and install Snap-
Toggle Anchors (D) per instructions below.
STEP 14
Once all Snap-Toggle anchors are securely fastened
in the wall, realign the wall frames and use wall
connection bolts and a washer to secure the furring
strips to the wall.
STEP 15
Adjust leveling feet using a flat head screwdriver until
wall is level and all feet are against the floor.
NOTES FOR OTHER WALL TYPES
If installing on walls without standard gypsum
installation, use specialty wall anchors for each
construction type, and the smaller holes on each
furring strip to securely anchor. Each anchor point
must be able to handle a 200lb load.
CONNECT WALL FRAMES TO THE WALL
(These instructions are for gypsum board wall construction. For other wall construction methods, see notes below.)
Summary of Contents for asurion uBreakiFix Fixture
