24
9.3
Remove the mold heater by first wiggling it to the left, and then pulling it
upwards after it is disconnected.
9.4
Install the magnetic solution stirrer in place of the mold heater. First lay
the agitation module on the bottom of the cavity (the connector pointing
to the right), and then slide it rightwards, to connect it fully.
9.5
Put the beaker on the agitator.
In the last steps of the fusion program, the magnetic stirrer will automatically
start, just before the crucible pours the melt into the acid.
Description of
the fusion steps
All fusion programs in the K1 Prime are built the same way, and have nine (9)
steps. Here is the list of those steps, along with the corresponding icon:
2
1
Summary of Contents for K1 PRIME
Page 1: ...Automatic fluxer 1...
Page 2: ......
