6 / 8
2.2.4.3 Switching the output signal on/off
The output channel can be switched on/off via the “RF on/off” parameter.
This setting can be speci
fi
ed individually for each output channel.
*** UFO 395-Q1 ***
823.25MHz Standard B/G
HF Level max
Stereo Vol + 0d B
On
2.2.4.4 Setting the common output level
The parameter “Output Level” allows the output level of the output channel to be
continuously varied in 40 steps (approx. 20 dB).
The setting limits are designated “Min” and “Max”.
This setting is applied directly on the adjacent channel also (for Q1 on Q2 and
for Q3 on Q4).
*** UFO 395-Q1 ***
823.25MHz Standard B/G
HF on Level
Stereo Vol + 0d B
max
2.2.4.5 Selecting the audio mode
Selecting the audio mode.
The scroll buttons allow selection of the following audio modes:
“Auto”, “Mono”, “Stereo”, “2-channel”, “2-channel A” and “2-channel B”
*** UFO 395-Q1 ***
823.25MHz Standard B/G
HF on Level max
Vol + 0d B
Note:
- In “Auto” the audio mode is set by the SAT signal
- In “2-channel A” only channel 1 is transmitted during 2-channel reception
- In “2-channel B” only channel 2 is transmitted during 2-channel reception
Stereo
2.2.4.6 Setting the Volume
Select the parameter “Volume”.
Perform the volume setting using the scroll buttons.
The adjustment range is from -3 through 0 to + 3 dB.
*** UFO 395-Q1 ***
823.25MHz Standard B/G
HF on Level max
Stereo Vol + d B
0
