6
Tag reader FTR 100
Product description:
1.
Power LED (green)
2.
Status LED (red)
3.
Arm button
4.
Disarm button
5.
Batteries
6.
Function switches
7.
Tamper contact
8.
Tag (watertight)
LED indicators:
In stand-by mode, both LEDs are off.
•
Power LED (green):
o
If a button is pressed, the power LED lights up for 5 seconds to
indicate the readiness of the tag reader.
o
The power LED flashes instead of being on constantly to indicate a low
battery level.
•
Status LED (red):
o
Flashes fast upon signal transmission.
o
Is permanently on in tag learn mode.
o
Flashes in installation mode.
Battery:
•
The tag reader requires three AAA 1.5 V alkaline batteries. The average
battery life is approx. four years (two activations per day).
•
The tag reader indicates the low battery status by the power LED flashing.
The alarm panel is additionally informed about the battery status.
Power saving function:
•
As long as the tag reader is not used, it does not consume any electric
power. Only when a button is pressed is the tag reader activated for 5
seconds.
•
The tag reader automatically switches off again after 5 seconds.
Tamper protection:
•
The tag reader is protected from unauthorised opening or removal.
•
If the tamper contact is triggered, the power LED lights up and a warning
signal sounds. The alarm panel is informed about the tampering.
•
If the alarm panel is armed, opening the tamper contact triggers an alarm.
•
In learn mode, the tamper contact is deactivated.
