7
Function switches:
If the tag reader’s housing is open, you will see the function switch block with five
switches. These switches are all set to OFF by default.
Installation of the tag reader:
1.
Install the tag readers only indoors.
2.
Remove the front of the tag reader by unscrewing the lower screw.
3.
Use both screw holes to mark the drill holes at the wall.
4.
Make sure that the tamper contact of the tag reader lies flat against the
mounting surface.
5.
Screw the tag reader to the wall.
6.
Insert the batteries. The power LED lights up for a few seconds and a signal
sounds.
Connecting the tag reader FTR 100 and putting it into operation
1.
Open the menu “Sensors”
“Add” and press “Start” in the web interface of
the alarm panel.
2.
Start the installation mode of the Tag Reader by pressing the Arm or Disarm
button and then promptly setting switch 1(SW1) to ON. The Status LED starts
flashing and one long signal is followed by two short signal sounds.
3.
Press the Disarm button of the tag reader.
4.
The alarm panel indicates the tag reader as “Keypad” (XT1) or “Tag reader.”
5.
Add the tag reader to the alarm panel.
6.
End the installation mode of the tag reader by setting SW1 to OFF again,
which is acknowledged with four short signals. Then reinstall the front of the
tag reader by tightening the lower screw.
Note:
•
The installation mode ends automatically after five minutes. To restart the
installation mode, you need to set SW1 to ON again.
•
Make sure that the tampering contact of the tag reader is not pressed in
during the add process!
Switch no.
Position
Description
SW 1
ON
Learn / add mode
OFF
Normal operation (default)
SW 2
ON
Factory settings
OFF
Normal operation (default)
SW 3
OFF
System settings
MUST be
OFF
, as otherwise no
function
SW 4
OFF
SW 5
OFF
Reserved
