INITIAL SETTING
23
The following settings are possible:
⇒
22 kHz
Off, High/Low or Pos. 1/2
⇒
Tone Burst
1)
Off, High/Low or Pos. 1/2
⇒
Full DiSEqC
2)
Off, On or Remote Mode
1)
Tone Burst (simple DiSEqC)
2)
Full DiSEqC (to Eutelsat specification)
The setting is dependent on the receiving system
that is used.
Therefore look carefully at the specification of the
receiving system and the other components con-
tained within the receiving installation, such as
change-over matrices, for example.
Presetting: 22 kHz signal Off.
Search Menu
Search ON or OFF
In the Search Menu, you specify whether a search
run is to be carried out after the receiver is
switched out of operation into standby mode.
After finishing the search the unit switches into
standby.
Presetting: On
In the Search Menu entries that follow on you set
the parameters for the search run.
•
Frequency band, Low or High
•
Orbit position
•
Oscillator
See also the Structure Menu at the end of the user
manual!
General directions
•
For particular queries relating to subscriptions
to DMX programs and problems concerning
smart cards contact (only for Germany):
Firma SELCO
Siedlerstraße 2
85774
Unterföhring
Germany
Telephone:
(+49)-89-95007-788
•
The copyright permits recordings of TV- and ra-
dio transmissions only for private or other indi-
vidual usage. Public broadcasting or dissemi-
nation of recorded transmissions or titles is not
permitted and incurs liability to pay compensa-
tion.
