5 / 9
Overview LED
Tab 1
LED ...
Status EXIP 414
“Power” LED
Lit green
Operation
Off
No voltage supply
“Stream” LED
Lit blue
Network connection generated
Flashes blue
Active streaming (data transfer)
Off
Network not connected
RF connections
Tab 2
Single-cable (EN 50494)
Quatro
Quad/DiSEqC™
RF1 (950-2,150 MHz)
14/18 V; 0/22 kHz
14 V; 0 kHz
14/18 V; 0/22 kHz
RF2 (950-2,150 MHz)
14 V; 22 kHz
14/18 V; 0/22 kHz
RF3 (950-2,150 MHz)
18 V; 0 kHz
14/18 V; 0/22 kHz
RF4 (950-2,150 MHz)
18 V; 22 kHz
14/18 V; 0/22 kHz
2. Network connection:
The LAN connection must be connected to the home network. Normal-
ly, the existing router (e.g. FRITZ!Box) will automatically assign an IP address.
On the Web interface, “Automatic” (default) will be set under “IP settings”.
3. “DC” connection:
Finally, the power supply is to be connected to the server first and then to the network volt
-
age.
Use
Specification
Ethernet
Connection to the network
10/100/1,000 MBit
DC socket
Connection of power supply unit
12 V/3 A
If switch/button is ...
the following occurs ...
Reset
held down for about
5 seconds
Reset to factory
setting
On/Off
pressed
Device is cut off from voltage
supply
Additional connections
Switch and button
Summary of Contents for EXIP 414
Page 19: ......
