10 / 44
Installation and Connection
Installing and Connecting the Turntable
Required Tools and Equipment
●
Circular drill, Ø 38 mm
●
Power drill
●
The following screws, depending on the roof structure:
– 6 sheet metal pan-head screws DIN 7981 – Ø 4.8 or
– 6 pan-head screws DIN 7985 – M5 with washers and
nuts
(material: galvanized steel or stainless steel)
●
Twist drill, Ø 2.5 or 5.5 mm
●
Round fi le and/or emery paper
●
Detergent
●
Open-ended or ring spanners, 10 and 11 mm across
fl ats
●
Knife
●
Crosshead screwdriver for M5 screws
●
Torx screwdriver, size 20
●
Torque wrench, capacity 5 to 11 Nm
●
Hexagon socket key, 5 mm
●
Two wooden beams to place the turntable on
●
Sealing adhesive (not included)
Unpacking and Preparing
Risk of material damage during transport!
►
Leave the turntable in the packaging to transport it to the vehicle roof.
►
The packaging can be opened in the middle. This gives you better access to the fi xing screws after the
unit and the inserts have been removed from the packaging.
►
Keep the original packaging: If it is necessary to send the unit for repair, use the original packaging to
prevent transport damage. The manufacturer accepts no liability for possible damage due to insuffi cient
packaging.
1. Loosen the six fastening screws (width across fl ats: 10 mm).
2. Carefully lift the turntable off the mounting plate and place it on the two wooden beams. Make sure that the cables
are not crushed where they emerge from the underside of the turntable.
Unpacking the turntable
For more information on mounting, see
Installing and Connecting the Turntable, p. 40.
