17 of 56
–
Secure the cable gland from inside the vehicle by tightening the ribbed nut supplied (Fig. A).
–
Note that the curing of the adhesive sealant depends on the ambient temperature and the humidity.
The final strength is reached only after approx. 2 days. However, this need not restrict further installation work,
since the mounting plate is held in place by the tightened screws.
5.1.5 Possibilities of the Turntable Installation
Variant with Cable Gland underneath the Turntable
1. Feed the ends of the cables with the connectors as far as possible through the cable duct into the interior of the
vehicle.
2. Lift the turntable and place it carefully on the mounting plate in the direction of travel (see Fig. E). Make sure not to
step on the connectors or kink or crush the cables.
3. Align the through holes on the turntable with the threaded holes on the mounting plate. When lowering, make sure
that the cables are fed through the cable gland and are not crushed.
4. Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening screws into the
thread. Tighten the screws to a torque of 6 Nm.
5. To prevent water vapour from inside the vehicle reaching the turntable through the roof gland, thread the three cables
through the sealing gasket supplied and insert the gasket into the roof gland until it reaches the stop, see Fig. E.
Make sure that no tensile load is acting downwards on the sealing gasket as this can cause it to fall out in the course
of time.
Fig.
E
Gasket with plug for
the unused duct
Battery/ignition
CAP converter,
second TV/Receiver
