34 of 56
Manually Lowering the Antenna to Park Position
9.2
Manual Lowering
1. Using a narrow flat-bladed screwdriver, lever the plastic cap in the
centre of the axis (see the arrow in the figure on the left).
➯
You can see an M8 hexagon head screw (WAF 13 mm).
2. Remove the M8 hexagon head screw using a socket wrench
(WAF 13 mm).
➯
You can see another thread.
3.
NOTICE
Risk of material damage!
►
Screw in the M12 screw only as far as to free the rocker
from the engagement on the tapered shaft.
Screw an M12 x 40 screw (minimum length: 22 mm) into this thread.
➯
The rocker is pushed off the taper seating on the tapered shaft and
the engagement is released.
4. Tilt the antenna to the park position.
5. Remove the M12 screw.
➯
You can put the rocker back on the tapered shaft.
6. Screw in the M8 screw and tighten it.
7. Replace the plastic cap.
NOTICE
Rocker displacement!!
Due to the loosening the rocker from the tapered shaft, the rocker
zero point position is lost.
►
It is necessary that an authorised dealer recalibrates the rocker.
8. Consult an authorised dealer.
