9
•
Circular cutter, Ø 38 mm
•
Flat-bladed screwdriver for M5 screws
• Drilling
machine
•
Galvanised raised head screws, depending on roof structure (Ø: 5 mm, sheet metal screws D 7981,
depending on roof panel structure) or raised head screws D 7985 with shims and nuts
•
Twist drill, Ø 2.5 or 5.5 mm
• Round
fi le and/or emery paper
• Cleaning
agent
•
Open-ended or ring spanners 10 and 11 mm across fl ats
• Knife
•
Cross-head screwdriver for M3 and M5 screws
•
Torque wrench between 6 and 11 Nm
•
Hexagon socket key (5 mm)
•
Two wooden beams for supporting the turntable
REQUIRED TOOLS AND EQUIPMENT
INSTALLATION AND CONNECTION
Keep the device in its cardboard box for transport on to the vehicle roof. Only take the turntable out of its
packaging when it is on the vehicle roof. Retain the original packaging, as if it is necessary to send the unit for
repair transport damage cannot be ruled out and the manufacturer accepts no liability for possible damage.
Loosen the six fastening screws (width: 10 mm). Carefully lift the turntable off the mounting plate and place
it on the prepared support beams. Make sure that the cables are not crushed where they emerge from the
underside of the turntable.
UNPACKING AND PREPARATION
Essentially, the cable lengths of the MobiSet 4 CAP 900 components allow you a free choice of installation
location on your caravan or motor home.
However, you should take note of the following points:
•
Before installation, you should fi nd out whether the operating manual for your vehicle permits the fi tting
of non-vehicle-specifi c parts or what requirements need to be met in order to do so.
•
For direct satellite reception, there should not be any obstructions between the antenna and the satellite.
Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks,
air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of the
parking place for your vehicle. For interference-free satellite reception, the antenna needs a projected
free view to the South at an angle of between 15° and 55° (depending on location) to the horizontal.
SELECTING THE INSTALLATION LOCATION