31 of 52
9.2
Manual Lowering
1. Using a narrow flat-bladed screwdriver, lever the plastic cap in the
centre of the axis (see the arrow in the figure on the left).
➯
You can see the following hexagon socket head cap screws:
1x M10 (WAF 8 mm) on each side, 2x M6 (WAF 5 mm) on one side.
2. Remove the four hexagon socket head caps.
➯
You can see another thread on each side.
3.
NOTICE
Risk of material damage!
►
Screw in the M12 screw only as far as to free the rocker
from the engagement on the tapered shaft.
Screw an M12 x 40 screw (minimum length: 40 mm) into this thread on
each side.
➯
The rocker is pushed off the taper seating on the tapered shaft and
the engagement is released.
4. Tilt the antenna to the park position.
5. Remove the M12 screw.
➯
You can put the rocker back on the tapered shaft.
6. Replace the four hexagon socket head cap screws and tighten them
firmly (1x M10 on each side, 2x M6 on one side).
7. Replace the plastic cap.
NOTICE
Rocker displacement!!
Due to the loosening the rocker from the tapered shaft, the rocker
zero point position is lost.
►
It is necessary that an authorised dealer recalibrates the rocker.
8. Consult an authorised dealer.
Summary of Contents for MobiSet 4 Twin CAP 950
Page 43: ...43 of 52...
Page 50: ...50 of 52 Declaration of Conformity 15 Declaration of Conformity...
Page 51: ...51 of 52...
