2 / 14
The following representation shows the
appearance of the display after plugging in the controller
.
The DVB-S(2) trans-modulator/multiplexer (2 x QPSK/8PSK on COFDM) is set up using the controller on the base unit UFG 404 or
UFG 412 or UFG 412/R.
Required controller software version:
from version V9.40
For setup, connect the controller to the module. The buttons listed below refer to the controller (see also the user instructions for the
UFG 404, etc. base units and the UFG 300 controller).
Setup instructions
Note:
The settings and numerical values shown below are intended as an example and do not necessarily match the
delivery status.
Select the
desired parameter
using the “<” and “>” buttons.
The
selected parameter
fl
ashes
in the display.
The
setting
is performed using the “+” and “-” buttons and where necessary using the “Change setting mode” button
.
The sub-menus are activated and deactivated by pressing the “Sub-menu” button
.
Finally, press “
M
” to
save
the setting in the module.
Note:
If the controller is disconnected from the module by pressing the “M” button without saving the settings,
the settings originally stored in the module are reactivated.
Main menu (all symbols shown)
E1
1236
MHz
*
TP
27.500
MS/s
3/4
QPSK
Outp. *
S21
306.00
MHz
8
MHz
QAM64
“*”
Left of “TP”:
Indicates “desired operating mode not yet reached”, displayed permanently in case of error.
If the indicator is
fl
ashing, the channel unit cannot operate properly.
Reasons for this include:
- Input frequency or symbol rate set incorrectly
- No input signal
Right of “Outp.”:
The channel unit output is switched off
■
Displays
Note:
The most up-to-date version of these user instructions can be found on the Kathrein homepage under:
“www.kathrein.de”
→
Service
→
Operating instructions
Note:
The indicator (“*”)
fl
ashes at top right during channel unit initialisation.
Summary of Contents for UFO 333/MX
Page 71: ......
