3 – 18
MAINTENANCE
Clean the Fuel Filter Element
* Hot oil and components can cause personal
injury.
* Fuel leaked or Spelled on to hot surfaces can
cause a fire.
WARNING
250HOURS
The fuel filter (1) is located rear of the engine.
1. Stop the engine.
2. Turn the fuel stop lever (2) to the “closed”
(OFF) position.
3. Loosen the ring nut (3).
4. Remove the cup (4) and the element (5).
5. Drain water and sediment into a suitable
container.
NOTE:
Always dispose of drained fluids as
established by local regulations.
6. Clean the inside surface of the cup (4) and the
element (5).
7. Install the clean element.
8. Inspect the O-ring (4). Replace it if they are
worn or damaged.
9. Install cup (4) on body and tighten ring nut (3).
10. Turn the fuel stop lever (2) to the “opened”
(ON) position.
NOTE:
Do not start the engine until all fuel system
service is completed.
Priming the system
There should be enough fuel in the system to allow
the engine to start. Keep the engine start switch
key at ON for a period of 20 seconds, which
operates the fuel pump and priming automatically.
Change the Coolant
Coolant should be drained and changed every 250
service hours or six months. However, when adding
“Long-Life-Coolant”, the drain period can be
extended to 2 years.
Drain the coolant earlier whenever the coolant is
dirty or foaming is observed.
See 3-9. (2 years Maintenance section).
Summary of Contents for 17VXE
