IMPORTANT NOTES
The T-45BL is only compatible with the CT5420 Brushless Electric Drivers.
The Power Supply can be used in US and Europe since the input voltage
can range from 100 VAC to 240 VAC (47-63 Hz). For the European market,
the Power Supply comes with a VDE style plug cord., see Figure 7.
TRANSFORMER SETUP
1. The T-45BL Power Supply should be securely fixed to the work table
.
Fasten the Mounting Bracket to the Power Supply using the included screw and secure
it flat to the work table or wall, see Figure. 5.
2. Turn the DC Output Switch to Low and the Power Switch to Off
, see Figure 6.
3. Connect the electric
driver’s power cord to the Power Supply and tighten using the knurl ring.
Make sure both ends are connected.
4. Connect the power cord to the back of the Power Supply and plug it into a 120 VAC outlet.
5. Turn on the Power Supply once you are ready to operate the driver
.
OPERATION
The T-45BL Power Supply is designed to operate the CT5420 electric drivers only. When the Power
Switch is turned On, the Power Indicator illuminates. This indicates that the Power Supply is
energized, and the operator can begin installation. After the insert has been installed, the driver
senses the spike in torque and sends a signal back to the Power Supply. The Power Supply reverses
the driver and the mandrel is threaded out. When the trigger is released, the Power Supply resets.
Note: Do not turn off the Power Supply while the driver is operating. This may cause damage to the
driver and/or the Power Supply unit.
BEFORE YOU BEGIN PLEASE REVIEW…
•
Proper hole preparation procedures.
•
A step by step instructional video can be found in the KATOpedia section of
the KATO website
Page 6
Figure 5
Secure flat to the work station or wall.
Figure 6
Figure 7
