- 109 -
W
ha
t to
do
w
hen
the
m
ac
hine
br
ea
ks
do
w
n
16. What to do when the machine breaks down
(1)
If the cause of the breakdown is not the engine and the engine may be used without causing problems:
1) Shift lever
…………………………
"N"
2) Start the engine.
3) Hazard warning switch
…………
"ON"
4) Allow an adequate distance between the towed and towing
machines, join the machines with a "tow bar", "wire rope" or
other means of sufficient strength, and tie a white cloth to its
midpoint.
5)
Attach a red flag etc. to the front and back of the broken-down
machine to show other drivers that this machine is under tow.
6)
Position a guide machine in front of the towing machine and a
supervising machine behind the towed machine.
7)
"Release" the parking brake and remove the "chocks" in front of
the wheels.
8) Begin towing.
(2) If the engine is the cause of the breakdown
1) Starter switch
………………
"ON"
2) Shift lever
…………………
"N"
3)
Supply compressed air to the broken-down machine.
Use a hose to connect the compressed air tank of the towing machine to that of the broken-down machine.
The supply of compressed air to the broken-down machine can be provided through the coupler on the underside
of the compressed air tank.
Then take the same actions as 4)
-
8) described in (1)
above " If the cause of the breakdown is not the engine and the
engine may be used without causing problems".
・
If you do not provide the broken-down machine with compressed air, the parking brake cannot
be released and the foot brake will not work during towing.
Supply compressed air until the "low air pressure warning lamp" goes out and remains unlit.
・
Be sure the compressed air supply hose does not get caught in the tires or touch the ground.
・
If the engine brakes down, the alternator will no longer supply the battery with electricity. Be
sure the battery has an adequate charge. Also be especially careful because the torque
converter oil can easily exceed the specified temperature range.
・
If the battery voltage is too low, the parking brake cannot be released. If the low-voltage
warning buzzer sounds while being towed, immediately stop towing the machine before the
parking brake is applied.
(T217321-170-0E)
Summary of Contents for PREMIUM CITYRANGE CR-200RF
