WARNING
19. For safe operation
- 176 -
3)
Escape from the cab being charged with electricity
If the machine is in the following conditions, jump out of the cab as distant from the machine as possible
immediately after leaving the operator's seat. Be careful that any part of your body does not come in contact
with the machine after landing. Contacting with the machine can lead to an electric shock.
1. The engine cannot be operated.
2. The crane is damaged and inoperable.
3. Other emergent conditions
4)
Be sure to use the machine involved in such an accident only after being inspected at your authorised KATO
dealer.
(
10
) Work according to signals
Choose one person to be the signaler.
If the signaler does not signal appropriately with the sling
handler and other workers, the working efficiency will fall and
there is the risk of accidents. Before starting the job, the
controller, signaler, sling handler and other workers who are
involved should confer on signal procedures in order to work
safely and steadily under the direction of the signaler.
(11)
Determine signals for joint operations
If two or more cranes are working together on a site, determine
the signaler and the signals in advance.
(12) Stop work in strong winds
・
Loads of high volume or side area and long booms are subject
to strong wind loads due to wind pressure. If the wind is strong
and is received from behind the crane, the wind load is added to
the suspended load mass which can cause the crane to tip over.
・
If a long boom derricked to a high angle is subjected to a strong
wind from the front, the crane can be tipped over.
・
If the wind has a gust speed of 10m/s or more, stop work
immediately, retract the boom and lower the load. If you are
working with a long boom or large load, stop work even if the
wind does not reach 10m/s.
Summary of Contents for PREMIUM CITYRANGE CR-200RF
