Tire Changer KT-830 User’s Manual
35
◇
As shown in figure 15-c, machine horsepower is not enough, check the triangle belt of
the motor by the following steps: (before any operation, to cut off the power) first,
Unscrew the 4 screws on the side of the box, remove the left side protective plate of the
tire changer, second, use special adjustment screw X (Figure 15-c) that is in the motor
support base to adjust the triangle belt.
◇
As shown in figure 15-d, If the (I) lock is not good or cannot be stopped at the top of the
2mm, it is necessary to adjust the nut on the operating arm.
◇
As shown in figure 15-e, when cleaning or replacing silencer which controls the opening
or closure of the clamps(G), follow the following steps: first, unscrew the 4 screws on
the side of the box, remove the left side protective plate on the tire changer. Second, in
the pedal (V1, V2) system which controls the opening or closure of the clamps(G),
unscrew silencer. Clean with compressed air nozzle, if damaged, replace with the same
parts.
