w w w . k a u
-6-
b e r . e u
3.
The delivered screen has end positions set in accordance with the order. If the surface of the screen
scrolls too low or not enough, correct the bottom end position using the included wrench (fig.3).
Before
adjustment, check in the warranty card which type of engine your screen is equipped with.
NOTE!
Adjustments to the end positions can only be made by a qualified person. All adjustments are
made at your own risk. In the event of an inaccurate adjustment, the screen may get damaged, which is
not covered by the terms of the warranty.
Access to the end stop
Fig.3
4.
In Blue Label Tensioned screens - once the surface is fully unfolded, you can use the allen key to adjust
the tensioning force (if necessary) with the screws located on both sides of the bottom bar.
White end stop
Yellow end stop
Access to the
end stops
Access to the
end stops
