3: After lower needle stop position is reached, time delay to the
parameter 205 set value [T1] then start trimming, time delay to the
parameter 206 set value [T2].
4: After upper needle stop position is reached, time delay to the
parameter 205 set value[T1] then start trimming, time delay to the
parameter 206 set value [T2], most applications are for interlock
machines.
5: find the needle position signal started first stop pin stop tangent
action. Tangent time delay [T2] and 205parameters of
the set time [T1] after the 206 parameter set.(most generally used for
car models, while T1 and T2 setting value most are set to 0)
6:203 parameters that are set at [TS] of the
tangent ,Toshiba first stop pin stop. Tangent
time delay [T2] and205 parameters of the set time [T1] after
2 0 3
5-359
10
Trimming start angle TS (relate to down needle stop position
angle)
2 0 4
10-359
120
Trimming finish angle TE (relate to down needle stop position
angle, the value should be bigger than TS)
2 0 5
1-999
10
Trimming start time delay T1
（
ms
）
2 0 6
1-999
120
Trimming finish time delay T2
（
ms
）
2 0 7
1
～
999
30
(Reserved)
2 0 8
1
～
9999
90
(Reserved)
2 0 9
1
～
999
120
(Reserved)
2 0 A
10-60
20
trimming force coefficient (motor force)
2 0 B
0
～
999
0
trimming short head feature selection
(0: off; non turn off delay time of 0:
1 after the needle)
19
