1
When it is set start/end back tacking sewing of A/B/C/D and
four segment sewing E/F/G/H
，
Select the
corresponding
key and the
key can set the segment
value addition and subtraction
，
the system default range is
1~F corresponds to the 1~15 pin.
2
But if you need to set the number of needles more, can be
specified to set the number of needles by modifying 11C
parameters and 11D parameters of ten, plus A/B/C/D and
E/F/G/H segment is a digit, together constitute the total
needle number. For example, in the setting of before and after
the solid needle number, the default 11C parameters
0000
3
If A
、
C segment set is E
，
B segment
、
D segment set is 4
，
A
、
C segment the actual needle is 14
，
B
、
D segment the actual
needle is 4.
4
The number of needle if any segment of the need to set more
than 15 needles, then adjust the 11C parameters. If the 11C
parameter is adjusted to 2121
5
At the same time, the corresponding A/B/C/D segment is set
to 1/6/1/6, then A segment, C segment the actual needle
number 21 needle, B segment, D segment actual pin number
for 16 needle. Thus, the actual number of each needle the
adjustable range can be extended to 1~99 needle.
4.6 Start/ end back tacking sewing and Four-segment sewing is set long
needle
36
