2. REMOVE THE TRUCK BODY
Pull out the clips and remove the body.
Make sure all accessories are properly attached, remove the pro-
tection film from the body before turning on the truck.
WARNING: Make sure the battery case, output terminals and charging socket
are not wet when you connect it to the charger! If any water on plug, there is
risc of fire and explosion!
Please only connect to the charger after drying the battery surface and battery termi-
nals.
3. INSTALL TRANSMITTER BATTERIES
1. Slide and remove the battery compartment cover. (Fig. 1)
2. Install 3x1.5 V AA alkaline batteries (not included) in correct polarities. (Fig. 2)
3. Replace the battery compartment cover. (Fig. 3)
NOTE:
1. Never mix different types of batteries.
2. Never mix new batteries with old ones.
3. Always remove exhausted batteries.
4. Always keep batteries out of reach of the children.
Fig. 1
Fig. 2
Fig. 3
Push
4. CHARGE AND INSTALL THE POWER BATTERY PACK
About 120 min
(1) Rotate the two battery locks in the indicated direction (until you hear a click meaning the locks have been released completely) and take the battery out.
3
a) Connect the battery to the USB Charger and plug the USB charger into a
power source (USB PC port, USB mains adapter 5V/2 A). The GREEN LED
on the USB starts blinking. This indicates the battery is being charged.
b) The green blinking turns steady when the battery is fully charged.