Instructions for use EXPERTtorque E680 - 1.006.4700EXPERTtorque Mini E677 - 1.006.0100
5 Operation | 5.4 Removing the bur or diamond
CAUTION
Use of burs with worn or damaged shafts.
Risk of injury, tool may fall out during treatment.
▶
Never use burs with damaged or worn shafts.
CAUTION
Danger of injury from bur.
Infections or cuts.
▶
Wear gloves or finger guards.
CAUTION
Hazard from defective chucking system.
The bur could fall out and cause injury.
▶
Pull on the bur to check if the clamping system works properly and the tool
is firmly clamped. Wear gloves or a finger guard when you check, insert or
remove the bits to prevent injury and infection.
NOTICE
Tool shaft slips inside the chuck due to excessive speed of the tool or
abrupt engagement of the tool.
Property damage to tool shaft and chuck system, reduction of the service life of
tool and chuck system.
▶
Do not operate the tool at a higher speed than recommended by the manu-
facturer.
NOTICE
Use of burs with worn or damaged shafts.
Property damage to the chuck system, tool is difficult or impossible to remove
from the chuck system.
▶
Do not use burs with damaged or worn shafts.
▶
Forcefully press the push-button with your thumb and simultaneously insert
the bur to the limit stop.
▶
Check that the bur is securely attached by pulling on it.
5.4 Removing the bur or diamond
WARNING
Hazard from rotating bur.
Cuts, infection and burn injury.
▶
Never press the push-button while the bur is rotating.
▶
Do not touch the bur while it is rotating!
▶
Remove the bur from the contra-angle handpiece after treatment to avoid
injury and infection when putting it away.
NOTICE
Damage to the chucking system.
Property damage
▶
Do not press the push-button while the bur is rotating.
13 / 26
Summary of Contents for EXPERTtorque E680
Page 1: ...Instructions for use EXPERTtorque E680 1 006 4700 EXPERTtorque Mini E677 1 006 0100 ...
Page 24: ......
Page 25: ......
