77.3.3 D
Disinfection: Machine disinfection - external and internal
KaVo recommends thermodisinfectors in accordance with EN ISO 15883
that are operated with alkaline cleaning agents at a pH of max. 10 (e.g.
Miele G 7781 / G 7881 – validation was performed with the ""VARIO-TD"
programme, "neodisher
®
mediclean" cleaning agent, "neodisher
®
Z" neu‐
tralisation agent, and "neodisher
®
mielclear" rinsing agent and extends only
to the compatibility of materials with respect to KaVo products).
▶
For program settings as well as cleansers and disinfectants to be used,
please refer to the Instructions for Use of the thermodisinfector (com‐
plying with max. pH value of 10).
▶
In order to prevent negative effects on the medical device, make sure
that the interior and the exterior of the medical device are dry, and then
lubricate immediately with care agents from the KaVo care system.
Setup methods according to DIN EN ISO 17664
47
77.4 D
Drying
Manual drying
▶
Blow off the outside and inside with compressed air until water drops
are no longer visible.
Machine drying
The drying procedure is normally part of the cleaning program of the ther‐
modisinfector.
▶
Follow the instructions for use of the thermodisinfector.
Setup methods according to DIN EN ISO 17664
48
77.5 C
Care products and systems - Servicing
WARNING
Sharp cutters or grinders in the medical device.
Risk of injury from sharp or pointed cutters or grinders.
▶ Remove cutter or grinder.
CAUTION
Premature wear and malfunctions from improper servicing and care.
Reduced product life.
▶ Perform proper care regularly!
Setup methods according to DIN EN ISO 17664
49
Note
KaVo only guarantees that its products will function properly when the care
products used are those listed as accessories, as they were tested for
proper use on our products.
7.5.1 C
Care products and systems - Servicing: Care with KaVo Spray
KaVo recommends servicing the product after each time it is used, i.e. after
each automatic cleaning and before each sterilisation.
▶
Remove cutter or grinder.
▶
Cover the product with the CLEANpac bag.
▶
Place the product on the cannula and press the spray button for one
second.
Setup methods according to DIN EN ISO 17664
50
Summary of Contents for INTRAcompact contra-angle 0768 LHC
Page 17: ...1 004 8195 kb 20101015 03 en...
