– 6 –
5.
The next step requires one person on each end of
the main unit. Grasp the unit with both hands, one
under the front, the other under the rear (remember,
not the end) and carefully center the main unit on
top of the stand so that the hook brackets located
on the bottom rear of the main unit are inside the
stand side panels (A) and approximately one-third
of the rear, top edge of the side panels are exposed.
(See the illustration to the right)
ASSEMBLING THE STAND
Be sure that all parts are included before starting to assemble your unit.
PARTS PROVIDED
Side Panel (A)
2 pcs.
Back Board (B)
1 pc.
Pedal Board (C)
1 pc.
Screw (D) (M6 x 25)
4 pcs.
Screw (E) (ø4 x 16)
6 pcs.
Screw (F) (ø4 x 25)
2 pcs.
Adjuster (G)
1 pc.
Cord Clamp (H)
1 pc.
Headphone Hook Set
1 set.
1.
Insert the Adjuster (G) on the Pedal Unit.
2.
Untie the pedal cable on the bottom of the
Pedal Board (C).
3.
Slide the metal bracket located at the end
of Pedal Board (C) on to screws (a) and (b)
of Side Panel (A). Install tighten screw (E)
then tighten screws (a) and (b). Repeat this
procedure on the other end of the Pedal Board,
then raise the completed stand assembly.
4.
Fasten Side Panel (A) and Back Panel (B)
with two screws (F). Then fix Back Panel
(B) to Pedal Board (C) with four screws (D).
(E)
(F)
(D)
(H)
Adjuster
ø4 x 16
M6 x 25
ø4 x 25
Cord Clamp
(G)
(A)
(C)
(E)
(a)
(b)
(F)
(E)
(C)
(A)
(B)
CAUTION:
To prevent personal injury, do not handle
the main unit from the ends.
(D)
(A)
