High Speed Camera User Guide
17
d.
Connect the fiber cables as described in Figure 2.
Connect the Power Adaptor to the
JetCam
power supply connector. The
JetCam
requires 12V
power supply for proper function for camera. Please, refer
section 7.1.2
of this document for
exact Power Supply requirements.
e.
Turn on the camera and the frame grabber on and start your application software.
The system supports the following QSFP+ modules:
Module
Description
P/N
Compatible Cable
Single mode fiber
QSFP+
Allows of up to 10km
connection over single
mode fiber cable (8
cores)
KY-QSFP-10
MTP/MPO single mode
Single mode fiber
QSFP+
Allows of up to 10km
connection over single
mode fiber cable (2
cores)
KY-QSFP-CWDM
LC single mode, duplex
cable
Multi-mode fiber QSFP+
Allows of up to 300m
connection over multi-
mode fiber cable (8
cores)
KY-QSFP-3M
MTP/MPO multi-mode
Table 3
: JetCam supported QSFP+ modules
NOTE:
To remove the QSFP+ module, first remove the fiber cable connected to it, then gently pull the QSFP+
module’s locking mechanism (see Figure 3 and Figure 4) and remove module.
Please contact KAYA representative for details of those options.
Installation and Configuration
