High Speed Camera User Guide
29
9.1
Getting Started
The Vision Point application is the main interface for all camera setting and configurations.
9.2
JetCam Terminal control
A Mini USB port is available for individual link & general information status and firmware update.
The port uses a Silabs CP2101 chip. A driver from the Silabs website might have to be installed on
certain PCs to gain access to the terminal port. Free supporting driver can be found at:
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
After driver installation and USB connection is acquired a serial emulated terminal (i.e Tera Term
use is recommended) can be used with the following configurations, described in Table 14:
Parameter
Value
Baud rate
115200
Start bits
1
Stop bits
1
Parity
None
Flow Control
None
Table 14 : Serial emulated terminal configurations
The following commands are supported by the terminal; each command must be followed by carriage
return (Enter) in order to execute:
Command
Description
Firmware
Sets the system to firmware update mode. See 9.3 chapter for firmware
update information
Status
Prints the system and individual link status and general information
Table 15 : Terminal commands
NOTE: The commands are not case sensitive.
9
Using JetCam Camera
