Predator Frame Grabber User Guide
11
Essentials to get started
To begin using your Predator Frame Grabber, you must have a computer with the
following:
Processor with an Intel 64-bit architecture, or equivalent.
An availably x4 (or x8 or x16) PCIe slot. Gen 2 support is recommended to faster data
transfer.
Vision Point Application installation
KAYA Instruments doesn’t guarantee compatibility with all computers that have the above
specifications. Please, consult KAYA representative for any specific issue
.
Power supplies
The Predator board receives its power directly from PCIe slot of the motherboard.
According to PCIe standard 2.0, the board might consume up to 10W of power, while
actual power consumption depends on usage mode and interfaces.
In order to support PoCXP feature the boards is capable of supplying up to 13W of power
per each CoaXPress link.
The PSU connector (standard PCI power connector), located on the top right side of the
board. It may be used to supply PoCXP power for connected cameras.
Mechanical Specifications
