High Speed Camera User Guide
20
Connecting the interface cable to QSFP+ Module
In order to properly connect the fiber optic cables, the following steps must be taken:
1.
Remove the protective dust cover from the fiber-optic cable connector.
2.
Insert the fiber cable into the module, as shown in Figure 5.
3.
Firmly push on each cable, until you will hear a click.
NOTE: Additional connectivity option is available using QSFP+ to SFP+ Fiber Breakout cable.
Figure 5 : Connecting the cable to QSFP+ Module
Removing the QSFP+ Module
In order to remove the QSFP+ module, follow these steps:
1.
Turn the camera and the JetCam camera and the Frame Grabber off.
2.
Disconnect and remove all interface cables from the ports.
3.
Hold the pull-tab latch on the QSFP+ module with your index finger, and gently pull to release
the transceiver from the socket, as shown in Figure 6.
4.
Grasp the module between your thumb and index finger and carefully remove it from the port,
5.
Insert the clean dust covers into the module, as shown in Figure 8.
Figure 6 : Pulling the pull tab latch of a QSFP+ Module
Installation and Configurations
