High Speed Camera User Guide
43
11.3
Acquisition Control category
1
2
3
4
7
8
5
6
Figure 28 : Acquisition Control category
1.
Acquisition can also be controlled trough executing the relevant commands from the
“Acquisition Control” category
2.
The Frame Rate
(1)
can be adjusted in steps of 0.01Hz. The camera will modify the exposure
time if needed to achieve the desired frame rate. The Exposure Time-Frame Rate dependency
detailed below
3.
Exposure Mode:
a.
Timed – continues mode
b.
Trigger Timed – timed exposure initiated by received trigger. The exposure duration is set
according to the exposure time parameter
c.
Trigger Width - timed exposure initiated by received trigger. The exposure duration is set
according to the width of the current trigger width
4.
Setting Exposure Time
(2)
. If the desired exposure time is longer than 1 / frame rate, the
exposure time will be set to the maximum according to the frame rate (1/ frame rate)
5.
External exposure strobe enable
6.
External exposure strobe polarity selection
7.
Trigger Source:
a.
Link trigger 0 – the source of the trigger is the master fiber link.
b.
Line 1 – the source of the trigger is the external RX I/O of the first RS232 connection (see
section 8.3)
8.
Trigger software
Camera Features
