13.Use tool
①④⑫
to tighten the bolts for the
swing arm protector(J).
14.Please refer to user’s manual (A) for air
pressure requirements. Use compressed air to
inflate the tires and use the air pressure gauge (E)
to inflate to the standard value of 5psi.
15.Install the front wheel on the front hub, use
tools
①②⑥
to tighten the bolts(F) (torque
requirements 49-59N.m).
16.Align the rear wheel with the splines and push
on the rear axle, with the air nozzle cap facing
outward. Put on the nut/washer/spring washer first
then insert the cotter pin(K), keep the bending
angle greater than 180° (torque requirement
86-103N.m).
17.Insert the dust cover(C) into the positions
shown above.
18.Take out the battery, according to the user’s
manual (A), first tear off the seal on the battery,
add electrolyte, then install the battery cover and
wait for the subsequent installation into the battery
box.
