20. Please refer to
user’s manual (A) for air pressure requirements.
Use compressed air to inflate the tires and use
the air pressure gauge (B) to inflate to the
standard value of 5psi.
21. Install the front wheel on the front hub, and
use tool
⑤⑪
to tighten and fix front rim lock
nut(P) (torque requirement) 60-68N. m)
22. Align the rear wheel with the splines and
push on the rear axle, with the air nozzle cap
facing outward, install the slotted nut, dust cap
washer and spring washer(D), and use
①④
to
lock them. Then insert the cotter pin(D), the
bending angle is greater than 180°. (torque
requirement is 77-92N.m)
23. Insert the rubber dust cover (G) into the
position shown above of the front and rear wheels.