7
8. Raise the rear body, install the upper end of L
(rear shock assembly) on the rear shock
mounting base of the frame, and use
⑭
(torque
wrench)
⑩
(13mm socket)
④
(14 # wrench) to tighten N ( M10 * 1.25 bolts*2
and M10 * 1.25 nuts*2) fixing screws (the bolts are
front, the nuts are back, and the torque
requirement is 49-59 N·m).
9. As shown in the picture, install the lower end
of L (rear shock assembly) on the lower rocker
arm damping mounting base, and use
⑭
(torque
wrench)
⑩
(13mm socket)
④
(14 # wrench) to
tighten N (M10 * 1.25 bolts *2 and M10 *
1.25 nuts*2) fixing screws (the bolts are back, the
nuts are front, and the torque requirement is 49-
59 N·m).
**Insert Tie rod end from bottom of
knuckle/spindle. This is a tapered bolt that will
only fully seat if inserted from the bottom.
Please note Inserting from the top and tightening
will cause the tierod end and castle nut threads
to strip and tierod end will rub the rim
10.Use compressed air to inflate the tire. Check
the instructions for air pressure requirements and
inflate it to the standard value of 5psi.
