ZHEJIANG KAYO MOTOR CO., LTD.
www.kayomoto.com
- 25 -
adjusting nut
ADJUSTING THE REBOUND DAMPING OF THE REAR SHOCK ABSORBER
adjusting screws
You can adjust the rebound damping by adjusting the
screws with a screwdriver.
Turn counterclockwise to decrease damping(soft), or
turn clockwise to increase damping(hard)
MEASURE THE DISTANCE BETWEEN THE CENTER OF THE REAR WHEEL AND THE
REAR FENDER IN SUSPENSION
The measurement procedure is as below:
1. Place your motorcycle on its center stand stably.
2. Select a fixed point on the side of the rear fender and
mark it as "point 1".
3. Measure the distance from "Point 1" to the center of
the rear axle and record it as "A1".
4. Remove the motorcycle from the rack
MEASURE DISTANCE BETWEEN CENTER OF REAR WHEEL AND REAR FENDER
UNDER NO LOAD
The measurement procedure is as follows:
1.
The motorcycle is up right so that the center surface
of the tire is perpendicular to the ground
2.
Measure the distance from the center of the rear
wheel axle of the motorcycle to "point 1" and record it
as "A2".
3.
Use a single stand to support the vehicle
4.
Calculate the difference between "A1" and "A2" and
denote it as "D1".
The value of "D1" when KT250 motorcycle leaves
factory is shown below
D1
KT250
10
～
34mm
