ZHEJIANG KAYO MOTOR CO., LTD.
www.kayomoto.com
- 56 -
CHECK THE SHIFT LEVER POSITION
Shift Head
The inspection steps are as follows:
1.
Raise the whole vehicle so that the center plane of
the tire is perpendicular to the ground
2.
The line of sight is level with the tread surface, and
observe the position of the shift head
3.
The shift head should be level with the tread
surface or slightly lower than the tread surface
If the shift head is higher than the tread surface, the
shift head should be adjusted downwards; if the shift
head is excessively lower than the tread surface, the
shift head should be adjusted upwards.
ADJUST THE SHIFT LEVER POSITION
Shift lever fixing bolt
Adjusting Steps are as follows:
1.
Loosen the fixing bolts of the shift lever.
2.
Remove the shift lever.
3.
Turn the shift lever to a suitable position and install
the spline.
4.
Tighten the shift lever fixing bolt.
INSPECTION OR REPLACEMENT OF
SPARK PLUGS
The engine spark plug torque is 25
～
30N•m.
The spark plug must be disassembled regularly to
check the distance between the electrodes (0.6 ~ 0.7
mm). If the spark plug contains oil or cinder, wipe it off
with a wire brush or similar. Use a measuring
instrument to measure the distance between the
electrodes and adjust them to prevent abnormal
bending of the external electrodes. If the spark plug
electrode is rusty, damaged, or the insulator is broken,
the spark plug must be replaced.
NOTE
: The spark plug should be checked every 10
hours accumulated and replaced every 20 hours
accumulated.
NOTE
: If the engine performance drops, replace the
spark plug to restore normal performance.
