ZHEJIANG KAYO MOTOR CO., LTD.
www.kayomoto.com
- 65 -
[4] Ash content: Ash content refers to the inorganic matter obtained by calcining the remaining
residue after the sample is sintered under specified conditions, expressed in mass percentage.
When choosing a two-stroke engine oil, the following conditions should be met:
①
Has good lubricity;
②
Excellent cleanliness;
③
It can prevent premature ignition;
④
It can prevent the spark plug from scaling and forming deposits;
⑤
It can prevent the exhaust pipe from being blocked;
⑥
Meet low smoke emission requirements;
⑦
It has miscibility with fuel.
Regarding the choice of engine oil, KAYO recommends you choose TORCO GP-7 fully synthetic
engine oil (Exceeds JASO-FC, ISO-L-EGD, API-TC) as the one for KT250 models.
A bottle of that will be sent with the corresponding model. (Actually, This implementation will be
operated according to the relevant regulations of the country where the customer.)
The
recommended
fuel
mixture
ratio
(gasoline: engine oil) for each model is
KT250
Run-in period
30
：
1
After the run-in period
30
：
1
NOTE
: The oils shown above are only used for mixing with gasoline, not for gearbox lubrication.
KAYO chooses SJ 5W-40 four-stroke engine oil as the gear oil for the engines of various models.
The gear oil should be replaced every 20 hours.
MOTORCYCLE CLEANING
The cleaning of the vehicle is also an important part of the daily use and maintenance of the
motorcycle. Frequent cleaning of your motorcycle can keep your car in a good state of motion and
prolong its service life. You can clean your motorcycle through the following steps:
1.
Cover the exhaust system to prevent water from entering.
2.
Seal the electric door lock and all connectors with tape.
3.
Use a low-pressure water spray device to remove the mud and dirt on the surface.
4.
Use a special motorcycle cleaner to clean particularly dirty places.
5.
Flush with low-pressure water flow.
6.
Let the motorcycle air dry naturally.
7.
Drive the motorcycle for a short period of time until the engine reaches the working temperature.
8.
Lubricate the chain and all other parts that need to be lubricated.
WARINING
: Never use high-pressure water to clean the vehicle. Avoid direct contact with coils,
pipe plugs, carburetor or any electrical components.
