Zhejiang Kayo Motor Co., Ltd.
12
ATV Safety
Safety Gear
An approved motorcycle helmet is the most important part of your safety gear. An approved motorcycle helmet
can help prevent a serious head injury. Choose a helmet that fits snugly. Motorcycle dealers can help in selecting a
good quality helmet which fits properly.
You should wear eye protection when you ride. If a rock or a branch hits your eyes, the eye protection would
protect you from injury. Remember to wear goggles or a face shield.
Wear proper clothing when you ride. The proper clothes can protect you from injury. Wear a good pair of gloves,
strong boots that are over the ankle, and a long sleeve shirt
WARNING
！
1.
Checking maintenance items when the engine is running could be hazardous.
You could be severely injured if your hands or clothing get caught in moving ATV parts. Shut the engine off when
performing maintenance checks, except checking the engine stop switch and throttle.
2. Operating this ATV without wearing an approved motorcycle helmet, eye protection, and protective clothing
could be hazardous. Operating without an approved motorcycle helmet or eye protection would increase your
chances of a severe head injury or death in an accident. Operating without protective clothing also increases your
chances of severe injury in an accident. Always wear an approved motorcycle helmet which fits properly. Always
wear eye protection (goggles or face shield). You should also wear gloves, boots, long sleeve shirt or jacket.
Break-In Period
The first month is the most important in the life of your riding. Proper operation during this Break-In period will
be helpful for assuring maximum life and performance of your new vehicle. The following guidelines explain
proper Break-In procedures.
Maximum Throttle Percentage Recommendation:
During the first 10 hours of operation, you should always use less than 1/2 throttle percentage.
Change the Engine Rotating Speed:
Change the engine rotating speed during the Break-In period, which make parts ‘run’, then ‘unload’ (permit parts
to be cooling). Although it is just during the procedure of adding some pressure into engine parts Break-In period,
please be careful that it would not be loaded too much to damage the engine.
Avoid Constant Low Rotating Speed:
