EN
9
• On the top of the cover there are straps
with Velcro fasteners to fasten the flaps
when rolled up.
PREPARATIONS
1. Cover or tape over all sharp edges and
sharp or protruding parts on the caravan
so that the cover will not fasten or be
damaged.
2. Fold down external antennas, or remove
them and store in a safe place..
3. Close all the doors, windows and sun-roof.
UNPACKING
Unpack the caravan cover. The pack contains
the caravan cover, storage bag, straps and
clips.
SPREADING
1. Take the cover out of the bag and unroll it
alongside the caravan.
2. The front end of the cover is labelled
FRONT on the inside of the cover.
3. Unzip the flaps.
FITTING
1. Check that the cover has the right side
up – FRONT at the front end and turned
so that the label comes inside when the
cover is fitted.
2. Place the steps by the caravan, grip the
front end of the cover and carefully climb
up the steps.
3. Carefully pull the cover all the way to the
front end. Spread the front end over the
front of the caravan and then over the
sides, starting at the front.
4. Check that you can reach the back end of
the cover without climbing all the way up
the steps.
SAFETY INSTRUCTIONS
WARNING!
Never move the caravan, not even for a short
distance, with the cover on.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
TECHNICAL DATA
Size
579 x 220 x 250 cm
Weight
8.45 kg
Fabric Polypropylene
FITTING
WARNING!
• Be very careful when fitting this caravan
cover. At least 2 adults are need to fit it.
• Do not attempt to fit the cover in the
rain or strong wind.
• The roof of the caravan should be made of
metal, reinforced fibreglass, plastic or
rubber, and should be dry when fitting the
cover. The cover is suitable for roofs made
of all the above materials.
OPENING FLAPS
• The caravan cover has two opening flaps
that can be rolled up for easy access to the
caravan. This means that the cover suits
caravans with a door in the middle, on the
front of the side wall, or a door at the back.
