I&O manual
5
While it is housed in the front cowl in version I, which take in air from
the front.
To remove the filter in version I, proceed as following indicated.
To remove the packaging, follow these instructions:
1
Check for visible damage
2
Open the packaging.
3
Check that the packet containing the manual for use and
maintenance is inside
4
Dispose of the packaging material in accordance with current
legislation, at the appropriate waste reception or recycling site.
PRESERVE THE ENVIRONMENT!
Dispose of the packaging materials in compliance
with the national or local legislation in force in your
country.
Fig.2-7
DANGER!
CAUTION
The air filter must be cleaned by blowing it out with compressed air
or washing it in water. Before refitting the filter, make sure it is clean
and completely dry. If the filter is damaged, it must be replaced with
a genuine corresponding filter.
Do not leave the packaging within reach of children.
Handling instructions
CAUTION
2.3 Warnings and suggestions
Always avoid obstructing the flow of air or using the unit as a surface
to lean on, the use of water or aerosol sprays in proximity to the unit
can cause electric shocks and malfunctions.
3. INSTALLATION AND MAINTENANCE
3.1 Transport and handling
Packaging and components
CAUTION
DANGER!
DO NOT OPEN OR TAMPER WITH THE PACKAGING
BEFORE INSTALLATION.
The units should only be moved and lifted by specialized
personnel trained in these operations.
Check on arrival that the unit has not been damaged during
transport and that it is complete with all its parts.
DANGER!
Movement of the unit should be performed with care, in order
to avoid damage to the external structure and to the internal
mechanical and electrical components.
Also make sure that there are no obstacles or people along
the route, to avoid the danger of collisions or crushing and to
prevent the lifting or handling device from turning over.
All the operations listed below must be carried out in
accordance with current health and safety regulations, both
about the equipment used and as regards the procedure
followed. Before commencing moving operations, check that
the lifting apparatus has the required capacity for the unit in
question.
The units may be moved or lifted either by hand or by means
of a suitable trolley. If the weight of the unit is more than 30
kg, moving units need to be moved at the same time, it is
advisable to put the machines in a container and lift them by
means of a crane or something similar.
Storage conditions
Units in their packaging may be stacked not more than four
high and must be kept under cover.
Clearances and positioning
IMPORTANT!
CAUTION
Incorrect positioning or installation of the unit may amplify
noise levels and vibrations generated during operation.
The units may be mounted vertically, provided that the
correct clearances for positioning are maintained.
Fig.3-1
Summary of Contents for KFC-S-2T-250D
