KBAC SERIES INSTALLATION AND OPERATION MANUAL
8
FIGURE 4
KBAC-24D DRIVE LAYOUT (SEE LEGEND BELOW FOR NUMBERED ITEMS)
W
V
U
L1
L2
AC LINE
J1
1
2
14
11
10
4
3
13
12
8
6
5
15
16
MOTOR
17
7
LEGEND:
1.
Jog Terminal: Used with optional Run-Stop-Jog Switch Kit. See Section 14 on page 23.
2.
Adjustable Trimpots: Maximum Speed (MAX), Minimum Speed (MIN), Acceleration (ACCEL), Deceleration (DECEL), DC Injection Brake
(DECEL), Boost (BOOST), Current Limit (CL), Jog (JOG), Slip Compensation (COMP). See Section 12 on pages 21 and 22.
3.
Jumper J3: Automatic Ride-Through or Manual Start selection. See Section 10.3 on page 19.
4.
Jumper J4: Frequency Multiplier selection. See Section 10.4 on page 19.
5.
Jumper J2: Motor Horsepower selection. See Section 10.2 on page 19.
6.
Jumper J5: Motor Frequency selection. See Section 10.4 on page 19.
7.
Jumper J12: Switching Frequency and GFCI selection. Third Generation (3G) drives only. See Section 10.11 on page 20.
8.
Jumper J6: Adjustable Boost selection. See Section 10.5 on page 20.
9.
Jumper J7: Regeneration or DC Injection Braking. See Section 10.6 on page 20.
10.
Jumper J8: "Run" or "Fault" Output Relay Operation selection. See Section 10.7 on page 20.
11.
Jumper J9: Normally Open or Closed Stop Contact selection. See Section 10.8 on page 20.
12.
Jumper J10: Constant or Variable Torque selection. See Section 10.9 on page 20.
13.
Jumper J11: Factory use only.
14.
Connector CON1: Used to connect optional accessories to the drive.
15.
Jumper J1: AC Line Input Voltage selection. See Section 10.1 on page 19.
16.
Terminals L1A/L1B and L2A/L2B: Used for optional On/Off AC Line Switch Kit and RFI Filter Kit. See Section 14 on page 23.
17.
Terminal Block TB1: AC Line input and Motor connections. See Sections 7.1 and 7.2 on page 15 and 16.
