4
5.
Power Controller: the power can be adjusted among 0% and 100%. Users can adjust the
power value randomly based on the characters of the stuffs to be cleaned.
6. Empty the tank and clean both the outside and inside of the cleaner with a clean and dry
cloth for next use.
Attention
1)
In the process of cleaning, any loose tesseras may fetch way.
2)
Please don’t clean any cloth, leather, wooden stuffs which would fade easily via this machine.
3)
Please don’t clean cellphones,
watches which is not water-proof via this machine.
4)
Please don’t clean any shells, glass brackets which is made with hawksbill etc via this
machine.
5)
While the machine is working normally, the syntony of the ultrasonic wave and tank gives a
well-proportioned sound with no shudder on the surface of the water but sprays generated
by the tiny bubbles. If there are discontinuous surges, please add or reduce a little of
washing solution in the tank to stop the surges, which is good for get a better cleaning
effect.
6)
Please don’t make the machine work for a continuous long time (not more than 24 hours) as
possible as you can because a long-time working will raise the temperature of the case,
accelerate the burn-in process of inner electronic components and parts.
7)
Please don’t use flammable detergent.
8)
This device can not be used by individuals with limited physical knowledge, or the mental
disabled, or those lacking experiences or knowledge, such as children, unless they are
supervised by an individual who can take charge of their safety or have received training in
operating the device .
9)
DO NOT operate the unit without fluid in the tank. Always ensure that the fluid is no
higher than the max mark and no lower than the minimum depth of 7cm.
10)
Please prevent the cleaning solutions or water from getting into the case or being
splashed on the transducers because it may cause electric leakage and short circuit
or damage the wafers inside the transducers.
11)
If something gets into the case, please take it out immediately.
12)
When you change or drain the liquid inside the tank, please ensure that the liquid is under
common temperature, and that the ultrasonic function is turned off, and that power switch
is turned off.
13)
The more items you place in the cleaning bath, the less cleaning efficient you can
get. Leaving enough spaces among items rather than overlapping them is
recommended.
14)
Do keep the lid on during use. This will prevent splashes and reduce evaporation of the
fluid.
15)
DO NOT touch the power switch with wet hands.
16)
DO NOT disassemble the machine if you are not professional.
17)
DO NOT place the device on a soft surface where the vents can be blocked.
18)
Take care when adding or removing items from the cleaning tank as the splashed fluid is
likely to be hot and damage the internal components. Any splashed fluid must be dried
immediately.
