17
System prompts setup is successful.
4.4.3 Mode
The device suppers two work mode, including “this device as controller and “this device as
card reader”.
This device as controller: the device is used as an A&C controller for unlock
operation.
This device as card reader, the device is used as a card reader, if you need to control
door unlock, then it must be connected to an A&C controller before it can be used.
To set device mode:
Step 1. In system setup interface, press
【
↑
】
key or
【
↓
】
key, select mode setup, and
press
【
√
】
key.
Step 2. Select work mode, and press
【
√
】
.
Step 3. Press
【
↑
】
key or
【
↓
】
key, select work mode, and press
【
√
】
key as follows.
After selection is successful, a ○
√ will be shown next to work mode.
4.4.4 Reboot System
To reboot the system:
Step 1. In main interface, press
【
↑
】
or
【
↓
】
key, select system reboot, and press
【
√
】
.
System asks if to reboot or not.
Step 2. Select YES, and press
【
√
】
key to reboot.
4.5 System Info
You can view device card swiping info, alarm info and local info.
Work Mode
This device as controller
This device as card reader
○
√
IP Setup
IP
:
172.7.10.33
Sub Mask
:
255.255.255.0
Gateway
:
172.7.0.0