1
0
10
i n f o @ f l u r i d a a p p l i a n c e s . c o m
Inspect damages on the ice chute, cover and foams.
7-Testing
Fill water into the water reservoir to MAX FILL.
Plug the unit into power. Water Level LED illuminates in green and goes off.
Press Make Nugget once to start making ice.
You hear pump running and water dripping. You hear engine motor running
and making noise.
You hear fan running. Warm air exhausts at the back and the right side gets
warm.
Wait for 30 minutes and then dispense all ice. Fill water to MAX FILL, wait for 1
hour and then press and hold Make Nugget to stop making ice. Dispense all ice
and weight it.
8-Issues
Water leaks from the unit.
Water Level LED doesn’t illuminate when the water reservoir is full.
All LED flash simultaneously when the water reservoir is full.
The right side doesn’t get warm.
The unit doesn’t make ice and the Cleaning LED flashes.
The engine or motor makes clicking, clunking, slipping, grinding, squealing,
squeezing, or high pitch noise.
9-Causes
Upper water reservoir is damaged.
Lower water float is defective.
Water pump is defective.
The sealed system is defective.
Engine motor or auger is defective.
Summary of Contents for FDFM1JA01
